P1705

P1705 TP SENSOR

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
- GO TO 2.

2. CHECK DTC DETECTION

With CONSULT
1.Start the engine.
2.Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3.Drive vehicle and maintain the following conditions for 5 seconds or more.





4.Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P1705" detected?
YES- Go to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK DTC OF ECM

With CONSULT
1.Turn ignition switch ON.
2.Perform "Self Diagnostic Results" in "ENGINE".
Is any DTC detected?
YES- Check DTC detected item. Testing and Inspection (VQ-37VHR) or Testing and Inspection
(VK-56VD).
NO- GO TO 2.

2. CHECK DTC OF TCM

With CONSULT
Perform "Self Diagnostic Results" in "TRANSMISSION".
Is any DTC other than "P1705" detected?
YES- Check DTC detected item. Testing and Inspection.
NO- GO TO 3.

3. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
Is the inspection result normal?
YES- Replace control valve & TCM. Exploded View.
NO- Repair or replace damaged parts.