Removal and Installation

FRONT SEAT BELT

SEAT BELT RETRACTOR : Removal and Installation


REMOVAL


CAUTION:
Before servicing SRS, turn the ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes.
1.Remove the outer anchor.
- Remove the outer anchor cover.
- Remove the fixing anchor bolt of the outer anchor.
2.Remove the shoulder anchor.
- Remove the shoulder anchor cover.
- Remove the fixing anchor bolt of the shoulder anchor.
3.Remove the rear side finisher and rear pillar finisher. Removal and Installation.
4.Remove the seat belt bracket. Remove the fixing bolt of the seat belt bracket.
5.Remove the seat belt assembly.





- Disconnect the seat belt pre-tensioner connector.
NOTE:
- For installing/removing seat belt pre-tensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
- Disconnect the pre-crash seat belt connector.
- Remove the fixing screw and anchor bolt of the pre-tensioner seat belt retractor.

INSTALLATION

Install in the reverse order of removal.