Removal and Installation

SUNROOF MOTOR ASSEMBLY

Removal and Installation


REMOVAL


CAUTION:
- Before removing sunroof motor, check that glass lid is fully closed.
- After removing sunroof motor, never attempt to rotate sunroof motor assembly as a single unit.
1.Remove the headlining. Removal and Installation.





2.Remove sunroof motor assembly mounting screws (A).
Disconnect connector (B) from sunroof motor assembly and then remove sunroof motor assembly (1).

INSTALLATION


CAUTION:
Before installing the sunroof motor assembly, be sure to the place the link and wire assembly in the symmetrical and fully closed position.
1.Move the sunroof motor assembly laterally by little so that the gear is completely engaged into the wire on the sunroof unit assembly and mounting surface becomes parallel. Then secure the sunroof motor assembly with screw.
2.Install the headlining. Removal and Installation.