Trunk / Liftgate: Adjustments

TRUNK LID

TRUNK LID ASSEMBLY : Adjustment











1.Check the clearance and the evenness between the trunk lid and each part visually and by touching. (Fitting standard dimension in the table below should be satisfied.)







2.In case out of specification, adjust them according to the procedures shown below.
3.Loosen the bumper rubber.
4.Loosen the striker mounting bolts.
5.Lift up the trunk lid approximately 100 - 150 mm (3.937 - 5.906 in) height then close it lightly and check that it is engaged firmly with the trunk lid closed.
6.Check the clearance and evenness.
7.Finally tighten the trunk lid striker.