Removal And Installation

REAR DOOR GLASS


Removal and Installation


REMOVAL
1. Operate the power window switch to lower the rear door glass to the top bottom.
2. Remove rear door finisher. Rear Door Finisher.
3. Disconnect rear door speaker harness connector.





4. Remove rear door sash mounting bolts.

Arrow :Bolt

5. Remove outer corner cover mounting bolt (B) and rear door sash mounting nut (A) as shown in the figure.
6. Slide outer corner cover along door sash to remove.
7. Remove rear door glass run.
8. Remove rear door sash.

CAUTION:
Be careful not to damage sash tape when removing.
9. Remove hole cover.
10. Remove rear door glass mounting bolts.
11. Pull up door glass from the rear side, and then remove it from door panel toward the vehicle.

INSTALLATION
Install in the reverse order of removal.