Inspection

FRONT LOWER LINK


Inspection and Adjustment


ADJUSTMENT BEFORE REMOVAL
Adjust neutral position of 4WAS front actuator. (With 4WAS) Work Procedure (Pattern 1).

INSPECTION AFTER REMOVAL
Check front lower link and bushing for any deformation, cracks, or damage. Replace it if necessary.

INSPECTION AFTER INSTALLATION
1. Check wheel alignment. Rear Suspension Wheel Alignment Inspection.
2. Adjust neutral position of steering angle sensor. (Without 4WAS) Work Procedure.
3. Adjust neutral position of 4WAS front actuator. (With 4WAS) Work Procedure (Pattern 2).