Removal And Installation

TOE CONTROL LINK


Removal and Installation


REMOVAL
1. Remove tires with power tool. Removal And Installation.
2. Set suitable jack under axle housing.

CAUTION:
Check that jack supporting status is stable.
3. Separate shock absorber from axle housing. Removal And Installation.
4. Remove eccentric disk, adjusting bolt, mounting bolt, and nut. Remove toe control link.
5. Perform inspection after removal. Inspection.

INSTALLATION
Note the following, and install in the reverse order of removal.
- Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level ground.
- Perform inspection after installation. Inspection.