Removal And Installation

TRUNK ROOM LAMP


Removal and Installation


CAUTION:
- Disconnect the battery negative terminal or remove power circuit fuse while performing the operation to electric leakage.
- Never touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
- Never touch the glass surface of the bulb with bare hands because the surface is very hot just after the lamp is turned OFF to prevent a burns.
- Leaving the bulb removed from housing for a long period of time can deteriorate performance of the lens and reflector (causing dirty or clouding). Always prepare a new bulb and have it on hand when replacing the bulb.

REMOVAL





1. Insert a remover tool (A) into the gap between the lens to disengage fixing pawls as shown by the arrow in the figure, and then remove the lens.

Triangle: Pawl






2. Insert a remover tool (A) into the gap between the trunk room lamp case to disengage fixing metal clips as shown by the arrow in the figure, and then remove the trunk room lamp case.

Square: Metal Clip

3. Disconnect trunk room lamp harness connector.

INSTALLATION
Install in the reverse order of removal.