Removal And Installation

PERSONAL LAMP


Removal and Installation


CAUTION:
- Disconnect the battery negative terminal or remove power circuit fuse while performing the operation to electric leakage.
- Never touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to pre- vent damage to the bulb.
- Never touch the glass surface of the bulb with bare hands because the surface is very hot just after the lamp is turned OFF to prevent a burns.
- Leaving the bulb removed from housing for a long period of time can deteriorate performance of the lens and reflector (causing dirty or clouding). Always prepare a new bulb and have it on hand when replacing the bulb.
- Replace the personal lamp case as a set (right and left). After removing the headlining assembly, remove the personal lamp case. Exploded View.

REMOVAL
1. Remove headlining assembly. Removal And Installation.
2. Insert any appropriate tool into the gap between the lens to remove the lens.





3. Press the pawls (A) on both sides in the direction shown by the arrow in the figure using appropriate tool, and then pull out the personal lamp finisher.
4. Remove personal lamp case from headlining assembly.

INSTALLATION





Press the personal lamp finisher to the headlining. Pull the personal lamp case pawls in the direction shown by the arrow in the figure using appropriate tool.