Removal And Installation

ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)


Removal and Installation


REMOVAL
1. Disconnect battery cable from negative terminal.
2. Remove brake master cylinder cover and hood ledge cover. Removal And Installation.
3. Drain brake fluid. Draining.
4. Disconnect ABS actuator and electric unit (control unit) harness connector.
5. Loosen flare nut of brake tube using a flare nut wrench, and then remove brake tube from ABS actuator and electric unit (control unit). Exploded View.
6. Remove front RH tire with power tool.
7. Remove fender protector (rear) (front RH wheel). Removal And Installation.
8. Remove ABS actuator and electric unit (control unit) and bracket.

CAUTION:
- Never remove and never install ABS actuator and electric unit (control unit) by holding harness connector.
- Be careful not to drop ABS actuator and electric unit (control unit) and apply excessive impact to it.
9. Remove bracket, bushing and collar from ABS actuator and electric unit (control unit).

INSTALLATION
Note the following, and install in the reverse order of removal.
- When installing brake tube, tighten to the specified torque using a crowfoot and torque wrench so that flare nut and brake tube are not damaged. Exploded View.
- Never remove and install actuator by holding actuator harness.
- Bleed air from brake piping after installation. Service and Repair.
- Never apply excessive impact to actuator, such as by dropping it.
- Check that connector is fully locked after ABS actuator and electric unit (control unit) harness connector is installed.
- Perform decel G sensor calibration when ABS actuator and electric unit (control unit) is replaced. Work Procedure.