Disassembly And Assembly

OUTSIDE MIRROR


DOOR MIRROR ASSEMBLY : Disassembly and Assembly


CAUTION:
When removing, always use a remover tool that is made of plastic.

DISASSEMBLY
1. Remove door mirror assembly from front door. Removal And Installation.
2. Remove glass mirror. Glass Mirror.
3. Remove actuator assembly (2).





1. Remove inner cover (1) fixing screw (A), and then slide inner cover toward the direction of the arrow to remove.
2. Remove actuator assembly fixing screws (B).
3. Disconnect the harness connectors located behind actuator assembly.

NOTE:
For models with automatic driving position system, disconnect the harness connector (C).
4. Remove base from housing.





1. Remove base cover with a small flat-bladed screwdriver (A) wrapped into a protective tape.

Triangle: Pawl


CAUTION:
Apply protective tape (B) around base to protect the painted surface from damage.
2. Remove the mounting TORX bolts.
3. Write a short note to describe connector terminal layout, and then remove all connector terminals from harness connector.
4. Remove base through out harness connector.
5. Remove actuator bracket, power fold unit and side camera finisher.






Triangle: Pawl

1. Remove screws (A) fixing actuator bracket and side camera finisher to the housing.
2. Remove actuator bracket and power fold unit from housing.
3. Disengage the pawls, and then remove side camera finisher from housing.
6. Remove the fixing screws (A), and then remove power fold unit from actuator bracket.






ASSEMBLY
Assemble in the reverse order of disassembly.