Disassembly And Assembly

CENTER CONSOLE ASSEMBLY


Disassembly and Assembly


Disassembly and Assembly of Center Console Assembly

CAUTION:
When disassembling, always use a remover tool that is made of plastic.

DISASSEMBLY
1. Remove console finisher assembly. Removal And Installation.
2. Remove console tray.





1. Open the console lid assembly.
2. Insert a remover tool (B) between console tray (1) and hinge arm (2) and disengage connection of rear portion.

CAUTION:
- Slowly disengage connection of console tray.
- Never excessively pull console tray.





3. Rotate console tray as shown in the figure. Slide toward vehicle front end pull toward vehicle upper.

CAUTION:
- Slowly disengage connection of console tray.
- Never excessively pull console tray.
3. Remove console lid assembly.





1. Remove screws (A).

NOTE:
Do not lock console lid assembly. Perform the operation while console lid assembly is partly open.

CAUTION:
Be careful of the strong repulsive force of the spring.
2. Pull back console lid assembly.
4. Rear ventilator duct. Rear Ventilator Duct.
5. Remove inside key antenna (console). Console.
6. Remove console center finisher.





1. Remove screws (A).
2. Pull toward the arrow direction.

NOTE:
Remove the following parts after removing console center finisher (1).
- Power socket (2): Removal And Installation.
- USB connector (3): Removal And Installation Base Audio Without Navigation.

ASSEMBLY
Assemble in the reverse order of disassembly.

CAUTION:
When installing console lid assembly, tighten to the specified torque.

Tightening Torque: 3.5 Nm (0.36 kg-m, 31 in-lb)


Disassembly and Assembly of Console Finisher Assembly

CAUTION:
When disassembling, always use a remover tool that is made of plastic.

DISASSEMBLY
1. Remove console finisher assembly. Removal And Installation.
2. Remove cluster lid finisher (LH/RH) fixing screws, and then remove cluster lid finisher (LH/RH).
3. Remove cup holder assembly fixing screws, and then remove cup holder assembly.
4. Remove A/T control indicator fixing screws, and then remove A/T control indicator.
5. Remove infiniti drive mode selector.
6. Remove switch panel fixing screws, and then remove switch panel.
7. Remove ashtray assembly fixing screws, and then remove ashtray assembly.

ASSEMBLY
Assemble in the reverse order of disassembly.