Active Noise Control Unit

POWER SUPPLY AND GROUND CIRCUIT:_:ACTIVE NOISE CONTROL UNIT





Diagnosis Procedure
1.CHECK FUSE
Check for blown fuses.





Is the inspection result normal?
YES - GO TO 2.
NO - Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between active noise control unit harness connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - Check harness between active noise control unit and fuse.
3.CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect active noise control unit connector.
3. Check continuity between active noise control unit harness connector and ground.





Is the inspection result normal?
YES - INSPECTION END
NO - Repair harness or connector.