Removal And Installation

BODY SIDE TRIM


Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL

FRONT PILLAR GARNISH
1. Release front pillar portion of body side welt.





2. Remove front pillar garnish fixing clip and metal clip with a remover tool (A), and then remove front pillar garnish (1).

Circle: Clip
Square: Metal Clip


DASH SIDE FINISHER
1. Remove instrument passenger lower cover. Removal And Installation A/T Models (A/T models). Removal And Installation M/T Models (M/T models).
2. Remove kicking plate inner.





3. Remove clip (A).
4. Remove dash side finisher fixing clips with a remover tool (B), and then remove dash side finisher (1).

Circle: Clip


KICKING PLATE OUTER





Remove kicking plate outer fixing clips with a remover tool (A), and then remove kicking plate outer (1).

Circle: Clip


KICKING PLATE INNER
1. Disengage kicking plate inner mounting pawl on portion (A) as shown in the figure using a remover tool
(D).
2. Disengage kicking plate inner mounting pawls on portion (B) as shown in the figure using a remover tool
(D).

CAUTION:
Apply protective tape (E) on the parts to protect it from damage.
3. Pull kicking plate inner toward vehicle rear while pressing front end of kicking plate inner downward, disengage kicking plate inner mounting pawl on portion (C) as shown in the figure, and then remove kicking plate inner.











BODY SIDE WELT
1. Remove kicking plate inner.
2. Remove body side welt.

REAR SIDE FINISHER
1. Remove rear seat cushion and rear seatback. Removal and Installation.
2. Remove body side welt.





3. Remove rear side finisher (1) fixing clips with a remover tool (A), and then disconnect rear speaker harness connector.


Circle: Clip


4. Remove rear side finisher.

BACK PILLAR GARNISH





1. Remove back pillar garnish (1) fixing clips and pawls with a remover tool (A).
2. Remove back pillar garnish (1) from rear pillar finisher (2).

Circle: Clip
Triangle: Pawl
Square: Metal Clip

REAR PILLAR FINISHER
1. Remove rear seat cushion and rear seatback. Removal and Installation.
2. Remove body side welt.
3. Remove rear side finisher.
4. Remove front seat belt floor anchor bolt. Exploded View.
5. Remove rear seat belt floor anchor bolt. Exploded View.





6. Remove rear seat belt escutcheon fixing pawls with remover tool
(A), and then remove rear seat belt escutcheon (1) from rear pillar finisher (2).

Triangle: Pawl

7. Remove back pillar garnish.
8. Remove rear pillar finisher fixing clips, pawl, metal clips with a remover tool, and then remove rear pillar finisher.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press them in.