Brake Assist (With Preview Function)

PREVIEW FUNCTION





System Description

FUNCTION DESCRIPTION
When the Preview Function identifies the need to apply emergency braking by sensing a vehicle ahead in the same lane and the distance and relative speed from it, it applies the brake pre-pressure before the driver depress the brake pedal and helps improve brake response by reducing pedal free play.
The Preview Function shares component parts and diagnosis with the ICC (Intelligent Cruise Control) system.

CAUTION:
This system is only an aid to assist braking operation and is not a collision warning or avoidance device. It is the driver's responsibility to stay alert, drive safely and be in control of the vehicle at all times.

OPERATION DESCRIPTION

Operation
- The system detects the distance to the vehicle in front with the ICC sensor integrated unit of ICC and judges the necessity of emergency braking.
- The system detects the accelerator pedal release operation of the driver by the accelerator pedal position sensor and estimates the driver's brake operation intention.
- If the system is judged that the emergency braking is necessary and that the driver has the intention to operate the brake, the ABS actuator and electric unit (control unit) applies pre-pressure to reduce brake pedal play.

NOTE:
This system will not operate when the vehicle is moving at approximately 32 km/h (20 MPH) or less.

End of Operation
The pre-pressure function ceases when the following conditions are met:
1. When the driver depresses the accelerator pedal or the brake pedal.
2. If the driver does not operate the accelerator pedal or brake pedal within approximately 1 second.




Component Parts Location














Component Description









Diagnosis Procedure
1.PREVIEW FUNCTION DIAGNOSIS
When the preview function is not operating properly, the buzzer sounds and the preview function warning lamp will come on.

NOTE:
The preview function warning lamp shares the ICC system warning lamp.
- Go to ICC. Work Flow.