Special Repair Requirement

INSPECTION AND ADJUSTMENT


ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement

1.PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Insert the registered Intelligent Key* into key slot, turn ignition switch to "ON".
*: To perform this step, use the key that is used before performing ECM replacement.
3. Maintain ignition switch in the "ON" position for 5 seconds or more.
4. Turn ignition switch to "OFF".
5. Start engine.
Can engine be started?
YES - Procedure is complete.
NO - Initialize control unit. Refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.