Front Seat Belt

SEAT BELTS


Removal and Installation of Front Seat Belt







CAUTION:
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.

REMOVAL OF SEAT BELT RETRACTOR
1. Remove the outer anchor.
- Remove the belt tension sensor cover and cover protector (passenger side only).
- Disconnect the belt tension sensor connector (passenger side only).
- Remove the fixing bolt of the outer anchor.
2. Remove the shoulder anchor.
- Remove the center pillar lower and upper garnishes, refer to Locations Service and Repair.
- Remove the fixing anchor nut of the shoulder anchor.
3. Remove the seat belt assembly.





- Disconnect the seat belt pre-tensioner connector.

CAUTION:
- For installing/removing seat belt pre-tensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
- Disconnect the pre-crush seat belt connector (for only the vehicle with pre-clash seat belt).
- Remove the fixing screw and anchor bolt of the pre-tensioner seat belt retractor.

INSTALLATION OF SEAT BELT RETRACTOR
- Install in the reverse order of removal.
- Tighten by specified torque.

Tightening torque : 49.0 N�m (5.0 kg-m, 36 ft-lb)


REMOVAL OF SEAT BELT BUCKLE
Remove the seat belt buckle.





- Remove the front seat from vehicle, refer to Removal and Installation (For ease of tool operation in narrow space).
- Disconnect the seat belt buckle harness connector.
- Remove the fixing anchor bolt of the seat belt buckle.

INSTALLATION OF SEAT BELT BUCKLE
- Install in the reverse order of removal.
- Tighten by specified torque.

Tightening torque : 49.0 N�m (5.0 kg-m, 36 ft-lb)