Removal And Installation

CENTER CONSOLE ASSEMBLY


Removal and Installation


CAUTION:
When removing, always use a remover tool that is made of plastic.

REMOVAL
1. Put selector lever in drive position (7AT models only).
2. Remove selector lever knob (7AT models only).
- 2WD models: Refer to Exploded View
- AWD models: Refer to Exploded View
3. Remove shift lever knob (6MT models only). Refer to Exploded View.
4. Remove console finisher.





- Remove clips from rear of console finisher (1), and then remove pawl of front.
- Pull console finisher (1) upward to disengage from center console.
- Disconnect harness connectors.





5. Remove screws (B) of center console front side with screw driver (A).
6. Remove rear upper console assembly (7AT models only).





- Slide to front, pull up rear upper console assembly (1), and disconnect metal clips.
- Disconnect heated seat switch harness connectors.
(with heated seat)





7. Disconnect auxiliary input jacks connector (A) and power socket harness connector (B) (7AT models only).
8. Disconnect console sub harness connectors (A) (6MT models only).





9. Disconnect heated seat switch connector (A) (6MT models with heated seat only).
10. Remove coin pocket fixing pawl using a remover tool (A), and then remove coin pocket (1) (6MT models only).





11. Insert a deep-well socket wrench (A) to rotate adjusting nut to loosen cable sufficiently (6MT models only). Refer to Parking Brake System Lever Type.





12. Remove console rear finisher.
- Pull back the console rear finisher (1).





- Disconnect inside key antenna connector (A).





13. Remove console mask.





- Open the console lid.
- Pull up console mask (1) by using a remover tool (C), and disengage pawls.

14. Remove screws (C) of center console rear side, and then remove center console assembly (1).





INSTALLATION
Install in the reverse order of removal.