Removal and Installation

ROOF LOCK ASSEMBLY


ROOF LATCH MOTOR : Removal and Installation


REMOVAL

CAUTION:
Protect the rear fender with a fender protector.

NOTE:
Operate roof manually if it does not operate electrically. Refer to .
1. Remove roof lock assembly. Refer to Removal and Installation.
2. Remove retaining plate, and then remove roof latch motor shaft.
3. Disconnect roof latch motor harness connector.
4. Remove mounting bolt, and then remove roof latch motor.

INSTALLATION
Install in the reverse order of removal.

NOTE:
- Perform initialization according to the work after installing roof latch motor. Refer to Description Special Repair Requirement, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Description".
- Adjust door glass and quarter window glass. Refer to Inspection.
- Perform water leakage test. Refer to Water Leakage Test.