Removal and Installation

TRUNK LID


TRUNK LID HINGE : Removal and Installation


REMOVAL
1. Remove trunk lid assembly. Refer to Removal and Installation.
2. Remove shim (trunk lid side).
3. Disconnect harness connectors and clips from trunk lid hinge.
4. Remove trunk lid stay. Refer to Removal and Installation.
5. Remove following part. Refer to Removal and Installation.
- Trunk floor spacer center
- Trunk floor carpet
- Trunk rear plate
- Trunk room trim cap (LH/RH)
- Jack lid assembly
- Trunk floor trim (LH/RH)
- Rear wheel finisher
- Trunk center box (with spare tire)
- Spare tire (with spare tire)
6. Remove hydraulic unit assembly mounting bolts. Refer to Removal and Installation.
7. Remove trunk lid drive cylinder (LH/RH). Refer to Removal and Installation.
8. Remove mounting bolts and nut. Remove trunk lid hinge.
9. Remove shim (body side).

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check the trunk lid open/close operation after installation.
- When removing and installing the trunk lid hinge assembly, perform the fitting adjustment. Refer to Trunk Lid.
- After installation, apply touch-up paint (the body color) onto the head of the hinge mounting nuts.