P0600

SYSTEM DESCRIPTION
These circuit lines are used to control the smooth shifting up and down of A/T during the hard acceleration/deceleration. Voltage signals are exchanged between ECM and TCM (Transmission control module).




ECM Terminals and Reference Value
Specification data are reference values and are measured between each terminal and 48 (ECM ground).

ON BOARD DIAGNOSIS LOGIC:

DTC CONFIRMATION PROCEDURE

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next lest.

With CONSULT-II
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.




3. Wait at least 10 seconds.
4. If DTC is detected, go to "Diagnostic Procedure".

EC-AT/C-01:

EC-AT/C-01 - Connector Views:

WIRING DIAGRAM

Step 1:

Step 2:

Step 3:

DIAGNOSTIC PROCEDURE