Procedure 2 Inspecting Malfunctioning Parts - CONSULT Scan Tool

Inspecting SRS malfunctioning parts by using CONSULT-II - Diagnosis mode




1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" to Data link connector.




3. Turn ignition switch "ON".
4. Touch "START".




5. Touch "AIRBAG".




6. Touch "SELF-DIAG [CURRENT]".





7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".




If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in "SRS Operation Check", go to DIAGNOSTIC PROCEDURE 4, Procedure 4 Inspect SRS Malfunctioning Record CONSULT Scan Tool to diagnose the following cases.
- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.

8. Touch "PRINT".
9. Compare diagnostic codes to "CONSULT-II Diagnostic Code Chart".
10. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
11. Turn ignition switch "OFF", then turn oft and disconnect CONSULT-II and disconnect both battery cables.

CONSULT-II DIAGNOSTIC CODE CHART("SELF-DIAG[CURRENT]") Part 1 of 3:

CONSULT-II DIAGNOSTIC CODE CHART("SELF-DIAG[CURRENT]") Part 2 Of 3:

CONSULT-II DIAGNOSTIC CODE CHART("SELF-DIAG[CURRENT]") Part 3 Of 3:

12. Repair the system as outlined by the "Repair order" in "CONSULT-II Diagnostic Code Chart", that corresponds to the self- diagnostic result. For replacement procedure of component parts.
13. After repairing the system, go to DIAGNOSTIC PROCEDURE 3 Procedure 3 Final Check After Repairs Using CONSULT Scan Tool for final checking. CONSULT-II can only show one seat bell pre-tensioner malfunction as self-diagnosis result at a time. Check self-diagnosis result with. CONSULT-II whether other malfunctions are detected after repairing one seat belt pre-tensioner malfunction.