Evaporative Emission Line Replacement - Engine

Evaporative Emission Line Replacement - Engine

Removal Procedure

Important: Clean the tube connections and surrounding areas before disconnecting in order to avoid possible evaporative emission (EVAP) system contamination.





1. Remove the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement (Upper Intake Manifold Sight Shield Replacement).
2. Disconnect the engine EVAP line (1) quick connect fitting from the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
3. Disconnect the engine EVAP line (1) quick connect fitting from the EVAP canister purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
4. Cap the intake manifold port and the EVAP canister purge solenoid valve in order to prevent possible EVAP system contamination.

Installation Procedure




1. Remove the caps from the intake manifold port and the EVAP canister purge solenoid valve.
2. Connect the engine EVAP line (1) quick connect fitting to the EVAP canister purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
3. Connect the engine EVAP line (1) quick connect fitting to the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
4. Install the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement (Upper Intake Manifold Sight Shield Replacement).