Off Road Lamp Bulb Replacement (UNJ)

Off Road Lamp Bulb Replacement (UNJ)

Removal Procedure




1. Remove the 6 fastener covers by inserting a flat-bladed tool into the slot on the passengers side of each cover and gently lifting upward.
2. Using a T25 Torx driver, loosen the six bolts (1) under the fastener covers.
3. Rotate the lightbar rearward so that the light bar is laying upside down on the roof.
Warning: Refer to Halogen Bulb Warning (Service Precautions).

4. Remove the bulb socket from the lamp assembly by rotating 1/4 turn counterclockwise.
5. Pull the bulb outward from the lamp socket.
6. Replace the bulb socket.

Installation Procedure

1. Install the bulb socket into the lamp assembly by rotating 1/4 turn clockwise.
2. Rotate the light bar to the correct orientation.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the fasteners.

Tighten the fasteners to 4.5 Nm (30 lb in).

4. Install the 6 fastener covers by aligning the tab to the drivers side and gently pressing inward into place.