Tachometer Inaccurate or Inoperative

Tachometer Inaccurate or Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category

Circuit/System Description

The instrument panel cluster (IPC) displays the engine speed based on the information from the engine control module (ECM). The ECM sends the engine speed information via the serial data circuit to the body control module (BCM). The BCM then sends the information via the serial data circuit to the IPC to display the engine speed.

Reference Information
Schematic Reference

Instrument Cluster Schematics (Instrument Cluster Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Instrument Cluster Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool Information

Circuit/System Verification

Engine ON, verify the scan tool Engine Speed parameter matches the tachometer display.

If the Engine Speed parameter does not match the tachometer display, replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for IPC replacement, setup, and programming