Power Brake Booster Outlet Front Pipe Replacement

Power Brake Booster Outlet Front Pipe Replacement

Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning (Brake Fluid Irritant Warning).

1. Turn the ignition switch to the OFF position.
2. Apply and release the brake pedal 20 times to deplete the hydraulic brake booster accumulator reserve.




3. Disconnect the power brake booster outlet pipe fittings (1).
4. Remove the power brake booster outlet pipe (2) from the hydraulic brake booster pump (3) and the master cylinder (4).

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the brake pipe fittings (1) of the power brake booster outlet front pipe (2) to the hydraulic brake booster pump (3) and the brake master cylinder (4).

Tighten the brake pipe fittings to 15 Nm (11 lb ft).

2. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure with RPO BRM) (Hydraulic Brake System Bleeding (Pressure with RPO BRM))Hydraulic Brake System Bleeding (Pressure without RPO BRM) (Hydraulic Brake System Bleeding (Pressure without RPO BRM))Hydraulic Brake System Bleeding (Manual with RPO BRM) (Hydraulic Brake System Bleeding (Manual with RPO BRM))Hydraulic Brake System Bleeding (Manual without RPO BRM) (Hydraulic Brake System Bleeding (Manual without RPO BRM)).