Power Brake Booster Inlet Hose Replacement

Power Brake Booster Inlet Hose Replacement

Special Tools

CH-47830 Holding Fixture


Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution (Brake Fluid Irritant Caution) .

1. Using a suitable tool, remove the brake fluid from the master cylinder reservoir.
Discard the brake fluid into an approved container.
2. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (LHD) (Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (LHD))Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (RHD) (Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (RHD)) .
3. Install the CH-47830 to the master cylinder assembly.
4. Position the CH-47830 with the master cylinder assembly in a vise.




5. Release the power brake booster inlet hose clamps (1).
6. Remove the power brake booster inlet hose (2).



Installation Procedure





1. Install the power brake booster inlet hose (2).
2. Install the power brake booster inlet hose clamps (1).
3. Remove the master cylinder assembly from the CH-47830 .
4. Install the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (LHD) (Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (LHD))Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (RHD) (Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement (RHD)) .