Scan Tool Data List

Scan Tool Data List

The Engine Scan Tool Data List contains all engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.

Use the Engine Scan Tool Data List only after the following is determined:

* The Diagnostic System Check - Computers and Control Systems is completed.
* No DTCs
* On-board diagnostics (OBDs) are functioning properly.

Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Engine Scan Tool Data List represents values that would be seen on a normal running engine.

Important: A scan tool that displays faulty data should not be used. The scan tool problem should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.

Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, Refer to Symptoms - Computers and Control Systems for diagnosis.Symptoms - Computers and Control Systems

The column labeled Data List indicates where a parameter can be located on the scan tool. Refer to the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed:
AIR
- Secondary Air Injection Reaction Data

All
- The Parameter is in all of the data lists indicated below.

CC
- Cruise Control Data

CMP
- Camshaft Position Data

COOL
- Cooling/HVAC Data

ED
- Engine Data

ET
- Electrical/Theft Data

EVAP
- EVAP Data

FT
- Fuel Trim Data

HO2S
- Heated Oxygen Sensor Data

ID
- Ignition Data

IM
- IM Data

IPC
- IPC Data

MF
- Misfire Data

TAC
- Throttle Actuated Control Data