Stability System Caution Indicator Inoperative

Stability System Caution Indicator Inoperative
Diagnostic Fault Information

Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Diagnostic System Check - Vehicle

Circuit/System Description
The instrument panel cluster (IPC) illuminates the stability system caution indicator by supplying ground to the lamp. The electronic brake control module (EBCM) sends a serial data messages to the IPC, in order to command the indicator ON or OFF.

Circuit/System Testing

Note: Diagnose all vehicle DTC's before using this diagnostic.

With the scan tool, select instrument panel special functions Lamp Test. Command the instrument panel warning lamps ON.
^ If the stability system caution indicator does not turn on, replace the IPC.

Repair Instructions

Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for EBCM and IPC replacement, setup, and programming