CVT Input Shaft Planetary Carrier Clearance Inspection

CVT Input Shaft Planetary Carrier Clearance Inspection

1. Measure the clearance between the 25 x 31 mm thrust shim (A) and the snap ring (B) using a feeler gauge (C), in at least three places. Use the average as the actual clearance.










2. If the clearance is out of the standard, remove the 25 x 31 mm thrust shim (A) and measure its thickness.






3. Select a new 25 x 31 mm thrust shim from the following table and install it, then recheck that the clearance is within the standard.

THRUST SHIM, 25 x 31 mm





4. After installing the all parts to the input shaft, check that the snap ring is seated in the snap ring groove on the input shaft, and that the ring outside diameter is 30.7mm (1.21 in) or less.