Tire Pressure Sensor Location

Tire Pressure Sensor Location

Special Tools Required

- TPMS trigger tool ATEQ VT55
NOTE:

- The TPMS tool is necessary to do this procedure.

- Let the vehicle sit for at least 5 minutes to allow the tire pressure sensors to switch to sleep mode.

- This procedure locates where the tire pressure sensors 1, 2, 3, 4 are mounted, when activated by the TPMS tool.

- Position the vehicle at least 10 ft (3 m) away from other vehicles that have tire pressure sensors.

1. With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle and the TPMS control unit. If it does not, troubleshoot the DLC circuit: Except Si model, Testing and Inspection Si model. Testing and Inspection

4. Using the HDS, bring up the TPMS data list, scroll down to the bottom, and locate the four tire pressure sensors ID numbers. These are the ID numbers assigned to each tire location.

5. Follow the HDS screen prompts to turn on the TPMS tool.






6. Hold the TPMS tool near the valve stem of one wheel, and activate the tire pressure sensor by following the prompts on the HDS.

7. The TPMS tool will display the sensor data including the sensor ID number.

8. Locate the tire pressure sensor ID numbers on the TPMS data list, and match it to the sensor number. Note the sensor location.

9. Turn the ignition switch to LOCK (0).