Front Seat Frame Replacement - Passenger's Seat (2-Door)

Front Seat Frame Replacement - Passenger's Seat

Passenger's Seat - 2-door

SRS components are located in this area. Review the SRS component locations SRS Component Location Index (2-Door) and the precautions and procedures Service and Repair before doing repairs or service.

Do the front passenger's weight sensor initialization; with the HDS, Programming and Relearning without the HDS Programming and Relearning after front passenger's seat frame replacement.

NOTE:

- Put on gloves to protect your hands.

- Apply oil to the pivot area of the slide locks.

- Apply multipurpose grease to the sliding area of the seat tracks.

- If the side airbag has deployed, replace the seat frame and related parts with new ones. Service and Repair

1. Remove the front seat. Front Seat Removal/Installation

2. Slide the front seat frame rearward fully, detach the clips, then remove the front rail covers (A) from the front of both seat tracks.






3. Slide the front seat frame forward fully, detach the clips, then remove the left rear rail cover (A) and the right rear rail cover (B) from the back of both seat tracks.

4. Remove these items:
- Front seat-back cover/pad Front Seat-Back Cover Replacement

- Front seat cushion cover/pad Front Seat Cushion Cover Replacement

- Front passenger's seat weight sensor. Front Passengers Weight Sensor Replacement (2-Door)

- ODS unit ODS Unit Replacement

- Front seat belt buckle Front Seat Belt Replacement





5. Detach the clips, then remove the recline inner covers (A), and the side airbag module holder (B) from the seat frame (C).

6. Install the seat frame in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.

- Make sure the seat wiring harnesses are routed properly and are not pinched.

- Do the front passenger's weight sensor initialization; with the HDS, Programming and Relearning without the HDS, Programming and Relearning if you replace the ODS unit.