Navigation System: Service and Repair

CD, DVD, and PC Card Removal/Installation

If the display Open and Close buttons do not work, you must manually open the display to remove the customer's Navigation DVD, CD, and possibly their PC card. Follow to the steps.

1. Remove the audio-navigation unit from the vehicle. Audio-Navigation Unit Removal/Installation (With Navigation)

2. On the bench, carefully pull the display (A) straight out (about 1/2 inch).






3. Fold down the display as shown.






4. Push the PC card eject button (A) to eject the customer's PC card (if installed). Power is not required for this function.

5. Remove the plastic lid (B) over the navigation DVD slot.

6. With the display open, temporarily reconnect the unit in the dash (to power it up).

7. Push the CD eject button (C), and navigation DVD eject button (D) (the button is behind the plastic cover and works only when the unit is powered) and remove the discs (hold the discs by their edges to avoid fingerprints). To avoid scratches, place the navigation DVD and the customer's CD in a jewel case if available.

8. Re-attach the plastic lid that hides the navigation DVD slot.

9. Close the display by first returning the display to the upward position, and then pushing the entire display straight back into the unit.

10. After installing the new audio-navigation unit, re-insert the navigation DVD, the customer's CD, and the PC card.