Intermediate Shaft Installation

Intermediate Shaft Installation

6-speed M/T Model (Si)

1. Install the new set ring (A) into the set ring groove (B) of the intermediate shaft (C).

2. Clean the areas where the intermediate shaft contacts the differential thoroughly with solvent or brake cleaner, and dry with compressed air.
NOTE: Do not wash the rubber parts with solvent.






3. Insert the intermediate shaft (A) into the differential until the set ring locks in the groove.
NOTE: Insert the driveshaft carefully to prevent damaging the oil seal (B).






4. Install the flange bolt (A) and the two shoulder bolts (B).






5. Install the heat shield cover (A), then tighten the three heat shield cover bolts.

6. Install the right driveshaft. Driveshaft Installation

7. Refill the transmission with the recommended transmission fluid. MTF Inspection and Replacement

8. Check the wheel alignment, and adjust it if necessary. Service and Repair

9. Test-drive the vehicle.