Side Airbag Replacement

Side Airbag Replacement

NOTE: If replacing the driver's airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the seat assembly Front Seat Removal/Installation and seat-back cover. Front Seat-Back Cover Replacement (2-Door)

3. Remove the mounting screws (A) and the side airbag (B).






Installation

NOTE:

- If the side airbag lid is secured by tape, remove the tape.

- Do not open the lid of the side airbag cover.

- Use new mounting screws tightened to the specified torque. When you replace a side airbag, make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.

- Be sure to install the harness wires so that they are not pinched or interfering with other parts.

1. Place the side airbag on the seat-back frame (A). Install new side airbag mounting screws (B).

2. Install the seat-back cover in the reverse order of removal. Front Seat-Back Cover Replacement (2-Door)

3. Install the seat assembly, Front Seat Removal/Installation then connect the side airbag harness 2P connector.

4. Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with other parts.

5. Do the battery terminal reconnection procedure. Procedures

6. Clear any DTCs. Initial Inspection and Diagnostic Overview

7. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.