Procedures

Throttle Body Cleaning

CAUTION
Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.

1. Check for damage to the air cleaner. If the air cleaner element is damaged, replace it. Testing and Inspection

2. Remove the throttle body. Removal and Replacement

3. Clean off the carbon from the throttle valve and inside the throttle body with a paper towel soaked in throttle plate cleaner.
NOTE:

- Remove the throttle body to clean it.

- Be careful not to pinch your fingers.

- To avoid removing the molybdenum coating, do not clean the bearing area of the throttle shaft (A).

- Do not spray throttle plate cleaner directly on the throttle body.

- Use Honda genuine throttle plate cleaner.

4. Install the throttle body. Removal and Replacement

5. Reset the ECM with the HDS. Initial Inspection and Diagnostic Overview

6. Turn the ignition switch to ON (II), and wait 2 seconds.

7. Do the ECM idle learn procedure. ECM Idle Learn Procedure