Rear Seat-Back Cover Replacement - Fold Down (2-Door)

Rear Seat-back Cover Replacement - Fold Down

Seat-back - Fold Down - 2-door

NOTE:

- Take care not to tear the seams or damage the seat covers.

- Put on gloves to protect your hands.

1. Remove the seat-back. Rear Seat Removal/Installation

2. Remove these head restraint.

3. Remove the screw, then remove the center belt guide (A).






4. Release the lower hook strip (A), and the clips.






5. Pull back the seat-back cover (A), then release the hook strips (B).






6. Pull out the seat-back frame (A) from the pad (B), then pinch the tabs on the ends of the head restraint guides (C), and remove them from the seat-back.

7. Remove the seat-back cover and pad from the seat-back frame.






8. Pull back the edge of the seat-back cover (A) all the way around, and release the hooks (B) of the horizontal wires (C) from the vertical wires (D) on the pad, and remove the upholstery rings (E), then remove the seat-back cover.






9. Install the cover in the reverse order of removal, and note these items:
- To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the upholstery rings and the hook strips.

- Replace all of the upholstery rings (A) fastening the seat-back cover (B) and pad wire (C) with new ones using commercially available upholstery ring pliers (D).