DTC 83

DTC 83: No VSP Signal

NOTE: If DTC 85 stored at the same time as DTC 83, troubleshoot DTC 85 first, then recheck for DTC 83.

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle at 7 mph (10 km/h) or more.
4. Check the speedometer.

Does the speedometer register speed?

YES - Go to step 5.

NO - Substitute a know-good ECM/PCM: Except Si Model and recheck. If no codes are shown, replace the original ECM/PCM: Except Si model.

5. Check the VEHICLE SPEED in the TPMS DATA LIST with the HDS.

Is the vehicle speed indicated?

YES - The system is OK at this time.

NO - Substitute a known-good TPMS control unit and recheck.