DTC 12-22

DTC 12-22: Right-front Wheel Sensor Installation Error (19 mph (30 km/h) or more)
DTC 14-22: Left-front Wheel Sensor Installation Error (19 mph (30 km/h) or more)
DTC 16-22: Right-rear Wheel Sensor Installation Error (19 mph (30 km/h) or more)
DTC 18-22: Left-rear Wheel Sensor Installation Error (19 mph (30 km/h) or more)

1. Test-drive the vehicle. Drive the vehicle between 19 mph (30 km/h) and 31 mph (50 km/h) for 70 seconds or more.

NOTE: Drive the vehicle on the road, not on the hoist.

2. Check the RF, LF, RR, LR WHEEL SPD in the ABS DATA LIST with the HDS.
Are all four the same indicated value?
YES - Intermittent failure, the system is OK at this time. Check for loose terminals between the wheel sensor 2P connector and the ABS modulator-control unit 25P connector. Refer to intermittent failures troubleshooting. Intermittent Failures
NO - Go to step 3.
3. Turn the ignition switch OFF.





4. Check the appropriate wheel sensor is properly mounted.
Is the wheel sensor installation OK?
YES - Replace the appropriate wheel sensor.
NO - Reinstall the wheel sensor, and check the mounting position.