DTC 52
DTC 52: Motor Stuck OFF1. Check the No. 10 (40A) fuse in the under-hood fuse/relay box.
Is the fuse OK?
YES-Reinstall the fuse, and go to step 2.
NO-Replace the fuse, and recheck.
2. Disconnect the ABS control unit 31P connector.
3. Measure the voltage between the ABS control unit 31P connector terminal No. 17 and body ground.
Is there battery voltage?
YES-Reconnect the ABS control unit 31P connector. Then go to step 4.
NO-Repair open in the wire between the No. 10 (40A) fuse and the ABS control unit.
4. Turn the ignition switch ON (II). Then check for voltage between the ABS control unit 31P connector terminal No. 16 and body ground.
Is there 0.3 V or more?
YES-Check for loose terminals in the ABS control unit 31P connector. If necessary, substitute a known-good ABS modulator-control unit, and recheck.
NO-Repair open in the wire between the ABS control unit and body ground (G202).