Park Assist Buzzer

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.

NOTE: The following procedure is for service of the buzzer transducer used in the rear park assist system. The buzzer transducer used in the front park assist system is integral to and serviced as a unit with the front park assist display on the top of the instrument panel near the center and close to the windshield.





1. Position the park assist buzzer (4) and mounting bracket (3) within the seat riser (1) cavity as a unit.
2. Reconnect the wire harness connector to the connector receptacle on the underside of the buzzer.
3. Position the tab of the mounting bracket for the buzzer to the top of the inboard side of the seat riser.
4. Install and tighten the screw (2) that secures the mounting bracket for the buzzer to the seat riser. Tighten the screw securely.




5. Position the seat riser cover (1) over the seat riser (3). Gently and evenly bend the cover far enough to engage the tabs that secure the edges of the cover to the top of the seat riser.
6. Reinstall the driver side front seat onto the top of the seat riser. .
7. Reconnect the battery negative cable.