Pinpoint Test BD: DTC U0230:00

Instrumentation, Message Center and Warning Chimes

Pinpoint Test BD: DTC U0230:00

Normal Operation

- DTC U0230:00 (Lost Communication With Rear Gate Module: No Sub-Type Information)- sets in the Instrument Panel Cluster (IPC) if data messages received from the rear gate module over the High Speed Controller Area Network (HS-CAN) are missing for greater than 5 seconds. For a complete list of all network messages, refer to Information Bus.

This pinpoint test is intended to diagnose the following:

- Rear gate module

- IPC (Instrument Panel Cluster)

PINPOINT TEST BD : DTC U0230:00

BD1 VERIFY THE CUSTOMER CONCERN

- Ignition ON.

- Verify that there is an observable symptom present.

Is an observable symptom present?

Yes
GO to BD2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

BD2 CHECK THE COMMUNICATION NETWORK

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: Network Test.

- Carry out the network test.

Does the rear gate module pass the network test?

Yes
GO to BD3.

No
REFER to Information Bus.

BD3 RETRIEVE THE RECORDED DTCs FROM THE IPC (Instrument Panel Cluster) SELF-TEST

- Check for recorded DTCs from the IPC (Instrument Panel Cluster) self-test.

Is DTC U3003:16 or DTC U3003:17 recorded?

Yes
GO to Pinpoint Test BI (U3003:16) or GO to Pinpoint Test BJ (U3003:17). Pinpoint Test BI: DTC U3003:16 Pinpoint Test BJ: DTC U3003:17

No
GO to BD4.

BD4 RECHECK THE IPC (Instrument Panel Cluster) DTCs

NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI (Programmable Module Installation) may not have been carried out.

- Clear the DTCs. Repeat the IPC (Instrument Panel Cluster) self-test.

Is DTC U0230:00 still present?

Yes
INSTALL a new rear gate module. CLEAR the DTCs. REPEAT the IPC (Instrument Panel Cluster) self-test.

If DTC U0230:00 is still present, INSTALL a new IPC (Instrument Panel Cluster). REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.