Cruise Control: Adjustments

Cruise Control Module (C-CM) (with Sensor) Adjustment

Vertical Alignment

NOTE: In order to align the Cruise-Control Module (C-CM), which is a radar sensor unit, the vehicle must be in a wheel alignment bay station so that the vehicle is level.

NOTE: Damage to the C-CM (Cruise-Control Module) bracket may affect correct alignment. When aligning the C-CM (Cruise-Control Module), inspect the C-CM (Cruise-Control Module) bracket for damage and repair as necessary before carrying out the alignment procedure.

1. Place the vehicle on a wheel alignment bay station.

2. Remove the C-CM (Cruise-Control Module) radar sensor unit fascia cover.

3. Locate the C-CM (Cruise-Control Module) radar sensor alignment screw.





4. Place a combination square level on the face of the C-CM (Cruise-Control Module) radar sensor unit and check alignment.





5. Keeping the combination square level on the face of the C-CM (Cruise-Control Module) radar sensor unit, adjust the pitch of the sensor by using an E5 inverted Torx bit to adjust the screw until the sensor is vertical and level.





6. NOTE: Prior to installing the C-CM (Cruise-Control Module) radar sensor unit fascia cover, clean and remove any debris on the front or back of the cover.

Install the C-CM (Cruise-Control Module) radar sensor unit fascia cover.


Horizontal Alignment

NOTICE: The engine must be running during the this alignment procedure. Failure to leave the engine running throughout the entire procedure results in the cancellation of the alignment procedure and the system remains non-functional.

NOTE: The horizontal alignment for the cruise control sensor is a software calibration. No manual adjustment is needed for this procedure. The scan tool calibrates the Cruise-Control Module (C-CM) radar sensor unit through the C-CM (Cruise-Control Module) calibration procedure.

1. Follow the scan tool on-screen instructions to carry-out the C-CM (Cruise-Control Module) calibration procedure.
- Follow the operating instructions shown on the Integrated Diagnostic System (IDS).

- After completion of the test, verify that the test completed successfully.

- Follow the prompts to drive the vehicle after successful completion of the test. This may take several minutes.