Pinpoint Test AL: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter
Handles, Locks, Latches and Entry Systems - With Intelligent Access (IA)
Pinpoint Test AL: An Individual Button/Feature Is Inoperative From The Remote Keyless Entry (RKE) Transmitter
Normal Operation
The Remote Keyless Entry (RKE) transmitter in the Intelligent Access (IA) key sends a radio signal to the Remote Functions Receiver (RFR) module based on the user selected RKE (Remote Keyless Entry) transmitter button. The RFR (Remote Functions Receiver) module then communicates the command to the Remote Function Actuator (RFA) module, and the RFA (Remote Function Actuator) module carries out the selected action.
Upon a request to lock/unlock the doors or release the luggage compartment lid, the RFA (Remote Function Actuator) module controls the door lock actuators or the luggage compartment lid latch. Upon a panic alarm request, the RFA (Remote Function Actuator) module sends a message to the Smart Junction Box (SJB) over the Medium Speed Controller Area Network (MS-CAN) to activate the turn signals and horn.
This pinpoint test is intended to diagnose the following:
- Door locks
- Horn system
- Luggage compartment lid latch release
- Turn signal system
- IA (Intelligent Access) key
PINPOINT TEST AL : AN INDIVIDUAL BUTTON/FEATURE IS INOPERATIVE FROM THE RKE (Remote Keyless Entry) TRANSMITTER
NOTE: The panic feature will only operate when the ignition is in the OFF mode.
AL1 VERIFY THE DOOR LOCK OPERATION
- Press the lock and unlock button on the driver door lock control switch while observing the door lock operation.
Do the door locks operate correctly?
Yes
GO to AL2.
No
GO to Symptom Chart - Electrical. Handles, Locks, Latches and Entry Systems - With Intelligent Access (IA)
AL2 VERIFY THE HORN OPERATION
- Enter the following diagnostic mode on the scan tool: SJB (Smart Junction Box) DataLogger.
- Select the SJB (Smart Junction Box) PID (HORN) and active command the horn on.
Does the horn sound when commanded on?
Yes
GO to AL3.
No
REFER to Horn.
AL3 VERIFY THE HAZARD LAMP OPERATION
- Place the hazard switch in the ON position.
Do the hazard lamps operate correctly?
Yes
GO to AL4.
No
REFER to Lighting and Horns.
AL4 VERIFY THE LUGGAGE COMPARTMENT LID LATCH RELEASE OPERATION
- Press the interior luggage compartment lid release button.
Does the luggage compartment lid latch release?
Yes
REPLACE and PROGRAM the inoperative IA (Intelligent Access) key. TEST the system for normal operation.
No
GO to Pinpoint Test AF. Pinpoint Test AF: The Luggage Compartment Lid Latch Release Is Inoperative/Does Not Operate Correctly