Pinpoint Test AE: DTC B00A0:54, B00A0:76, B00C0:49, B00C1:49, B00C2:49 or B00C3:49

Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS)

Refer to Wiring Diagram Set 46 for schematic and connector information. [1][2]Diagrams By Number





Pinpoint Test - Supplemental Restraint System (SRS)

Pinpoint Test AE: DTC B00A0:54, B00A0:76, B00C0:49, B00C1:49, B00C2:49 or B00C3:49

Refer to Wiring Diagram Set 46, Supplemental Restraint System for schematic and connector information. [1][2]Diagrams By Number

Normal Operation
The Occupant Classification System Module (OCSM) monitors each Occupant Classification System (OCS) weight sensor bolt for correct calibration/weight and identification. When the OCSM (Occupant Classification System Module) detects a fault from any of the 4 sensors or if an OCS (Occupant Classification System) system component has been installed new, it will store a DTC in memory and send a message to the Restraints Control Module (RCM).
The RCM (Restraints Control Module) will store DTC B00A0:09 in memory and send a message to the Instrument Panel Cluster (IPC) to illuminate the air bag warning indicator.





This pinpoint test is intended to diagnose the following:

- Wiring, terminals or connectors
- OCS (Occupant Classification System) system component
- Passenger seat track