Washer Pump

Washer Pump





Removal and Installation

WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTICE: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.

1. Remove the LF fender splash shield. For additional information, refer to Front End Body Panels Fender Splash Shield.

2. NOTICE: When replacing the washer pump, be careful not to damage the rubber grommet.

NOTE: To prevent spilling windshield washer fluid, drain the washer reservoir before washer pump removal.

Remove the washer pump in the following sequence:

1. Disconnect the electrical connector.

2. Disconnect the 2 washer hoses.

3. Remove the washer pump.





3. To install, reverse the removal procedure.
- Fill the washer reservoir with windshield washer fluid.