Power Window Switch: Service and Repair

Window Control Switch

NOTE: Driver window control switch shown, all others similar.









Removal and Installation

Passenger window control switch

1. Insert a non-marring tool under the window control switch bezel and pry upward.

2. Remove the window control switch from the door trim panel.

Master window control switch

3. Remove the front door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

4. Release the window control switch retaining tabs and remove the master window control switch from the door trim panel.

All window control switches

5. Disconnect the electrical connector(s).

6. To install, reverse the removal procedure.
- The master window control switch and the LH window motor must be initialized whenever battery voltage has been removed from the driver window control switch for greater than 3 minutes (for example, the battery or the master window switch is disconnected) or if a new driver window control switch is installed. For additional information, refer to Window Motor Initialization Programming and Relearning.