Removal and Replacement

Engine Mount









Removal

1. Release the 2 tabs and position the degas bottle aside.





2. Using a floor jack and a wooden block, support the engine.





3. NOTICE: The engine mount studs must be held while removing the engine mount nuts or damage to the powertrain may occur.

NOTE: Do not loosen the engine mount center bolt or the engine may become improperly positioned.

Use the holding feature to prevent the engine mount studs from turning, remove the 2 engine mount nuts.





4. Remove the 3 bolts and the engine mount.





Installation

1. NOTICE: The engine mount studs must be torqued or damage to the powertrain may occur.

Torque the engine mount studs before installing the engine mount.

- Tighten to 8 Nm (71 lb-in).





2. NOTE: Do not loosen the engine mount center bolt or the engine may become improperly positioned.

Install the engine mount and the 2 nuts.

- Tighten the 2 nuts to 80 Nm (59 lb-ft).





3. Install the 3 engine mount bolts.
- Tighten to 48 Nm (35 lb-ft).





4. Position the degas bottle on the 2 retainer tabs.