Seat - Front

Seat - Front

NOTE: Refer to the installation steps in this procedure for seat track-to-floor retainer tightening sequence and specification.

NOTE: Always install new seat track-to-floor bolts.









Removal and Installation

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS (Supplemental Restraint System). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Restraints and Safety Systems &/or Air Bag Systems.

2. Complete the removal by referring to the exploded view.
- Note the wire harness routing and retainer locations.

- Discard the seat-to-floor bolts.


Installation

1. Install 4 new seat-to-floor bolts by hand.

2. Install the new seat-to-floor bolts in the sequence shown.
- Tighten to 35 Nm (26 lb-ft).






3. Connect the wire harness.
- Route the wire harness as noted in removal.

- Attach the retainers.


4. Repower the SRS (Supplemental Restraint System). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Restraints and Safety Systems &/or Air Bag Systems.