Programming and Relearning

Roof Opening Panel Motor Initialization

WARNING: Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.

NOTE: A new roof opening panel motor only moves towards the VENT position until it is initialized.

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including:
- whenever the roof opening panel motor has been removed from the roof opening panel system.
- whenever the roof opening panel glass has been removed from the roof opening panel system.
- whenever the roof opening panel assembly has been removed from the vehicle.
- whenever a new roof opening panel motor has been installed.
- whenever a new roof opening panel glass has been installed.
- whenever a new roof opening panel assembly has been installed.

1. Turn the ignition OFF. For a new roof opening panel motor, only carry out Step 2. For an existing roof opening panel motor, only carry out Step 3.

2. For a new roof opening panel motor:

1. Turn the ignition ON.

2. Press and hold the front of the SLIDE control switch until the roof opening panel glass moves slightly past the full VENT position and suddenly returns back to the full VENT position.

3. Release and quickly press and hold the front of the SLIDE control switch while the roof opening panel glass moves to the full OPEN position and then back to fully CLOSED position (movement starts approximately 3 seconds after the switch is pressed).

4. Release the switch and verify successful initialization by performing one-touch open and one-touch VENT operations

3. For an existing roof opening panel motor:

1. Turn the ignition ON.

2. Using the SLIDE and/or TILT control switch, position the roof opening panel into the full VENT position.

3. Press and hold the front of the SLIDE control switch (for approximately 10 seconds) until the roof opening panel glass moves slightly past the full VENT position and suddenly returns back to the full VENT position.

4. Release the switch and quickly press and hold the front of the SLIDE control switch while the roof opening panel glass moves to the full OPEN position and then back to fully CLOSED position (movement starts approximately 3 seconds after the switch is pressed).

5. Release the switch and verify successful initialization by performing one-touch open and one-touch VENT operations